By having a whole house water filter system in your residence, you can be assured that various impurities that are found in your municipality’s water will be removed and prevented from entering into your home’s water supply. This means that elements like fluoride, chlorine, pesticides and other impurities will not interfere with you and your family’s health. You will be able enjoy tap water that tastes great and will also be able to save more money because you will not have to buy bottle water. The added bonus is that you will not have to worry about showering or bathing in impure water.
Guide for installing a whole house water filtration system.
Create A Location For Filter
The first thing that you will need to do is choose the location for the filter that can be easily accessible so that you are able to access the unit. You will need to access the unit if you have to change the filters. It is best to look for a location that is not too far from the shutoff valve.
The Pipe Will Need To Be Cut And The Shutoff Valve Need To Be Installed
In order to complete this step, you will need to cut off the water supply to the house. Cutting off the supply line for the water should occur as close to the shutoff valve as possible. It is important to follow the instruction manual from the manufacturer, so you can be certain that enough of the pipe is cut off to accommodate the filter. It will also need to accommodate the new connection fittings and the shutoff valve.
You will also want to install the shutoff valve on the side of your house where the supply line is located. If you have decided to sweat the valve, be sure to remove the interior portion of the valve before you decide to apply heat.
Mark Parts For Cutting
Try to dry-part as many of the fittings that you can. You may have to use an adapter on one or both ends of the filter, so you will be able to join the type and size of the pipe.
The final piece that is marked for cutting can be held in place directly against the end of the valve.
For each connection that you have, you will need to slide a nut on it, and then follow with compression rings to keep the nuts snug and tightly fastened in place. You can then turn your water on and check to see if there are any leaks.
Install A Jumper Cable If Necessary
You will need to check apec water filter reviews and see if the electrical panel in your home has a ground wire that is attached to the water pipe, or if the ground wire is attached to a rod that is located in the ground. If this ground wire is attached to the pipe instead of a rod, you will need to use a jumper cable to prevent filter interruption in the ground path.
A whole-house water filter system can help improve the quality of the tap water in your home. Over time, it can pay for itself by helping you save money on bottled water.